The CyberSync™ Trigger Transmitter mounts onto your camera's hot shoe to provide wireless firing. When your camera shutter is pressed
***PLEASE NOTE that when using the basic CyberSync™ Trigger Transmitter 2, while the CyberSync™ Plus model receivers are compatible, they are not necessary. The CyberSync™ Plus models are only needed if you are using the Cyber Commander™, or should you anticipate purchasing the Cyber Commander™ in the future. If you DO NOT plan on using the Cyber Commander™, the regular CyberSync™ (non plus model) receivers will suffice. If using the basic CyberSync™ Trigger Transmitter with the CyberSync™ Plus Model Receivers, and no Cyber Commander™, the channel dial on the receiver is not utilized. Be sure to only use the sync cord to plug into the flash units sync jack. The telephone cable provided with the CyberSync™ Plus models, is also only necessary when using the Cyber Commander™.
The CyberSync™ Trigger Transmitter mounts onto your camera's hot shoe to provide wireless firing. When your camera shutter is pressed, the CST2 will simultaneously send the firing signal to all of the flash units in your setup that are fitted with CyberSync™ receivers or transceivers. Simply match the frequencies across all components and you’re ready to shoot!
1 in. (width) x 3.1 in. (height) x 0.6 in.(depth)
System Frequency Range
16 frequencies spaced 2MHz apart (from 2.427GHz to 2.457GHz)
Secure 256-bit binary encoded packet, with validity verification
1/4000 typical delay from closing of camera contact to receiver sync output signal
2 years under normal use
Less than 4 Vdc
Theme by InStijl Media